Camron W. Fox wrote: > Alle, > > I am trying to install CentOS 5 on a Dual Xeon 5160 FJ RX200 S3. The > RAID hardware is an internal LSI MPT 1068 SAS/RAID controller (LSI > 1068SASIME-2300). I have downloaded the drivers (mptsas, mptscsih and > mptbase) and created the required floppy. > When I run linux dd after booting from either the DVD or Disk 1 of > the CentOS distro, it says it loads mptsas, mptbase and mptscsih and > then comes up with "No drivers of the appropriate type were found", > etc... Consequently, the RAID device is not found and no disks are > available for installation. > When I do this with RHEL5 Disk 1, the drivers load correctly and > there is no problem. > I went to the LSI Logic site to download the drivers directly from > there, but they apparently don't support RHEL5 as of yet for the > LSISAS1068. > Any assistance would be greatly appreciated. > > Best Regards, > Camron > Alle, Apparently, I should have just "trusted the process". Doing a regular install *without* the using the FJ driver disk works just peachy. Best Regards, Camron Camron W. Fox Hilo Office High Performance Computing Group Fujitsu America, INC. E-mail: cwfox at us.fujitsu.com