Thanks Robert, I have a Terminal Services Server that will be behind the inside interface, I need to forward hits on port 3389 eth1 to an IP address behind eth0. Richard Veale -----Original Message----- From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On Behalf Of Robert Spangler Sent: Thursday, June 14, 2007 10:31 PM To: CentOS mailing list Subject: Re: [CentOS] BQ/CentOs port forwarding On Thu June 14 2007 18:06, Richard Veale wrote: > Just bought a new BQ/CentOS box with full NuOnce load (Linux > 2.6.9-55.ELsmp, gcc 3.4.6, Red Hat 3.4.6-8, Apache 2.0.52, BQ 5102r), to > replace my old Qube 3 pro, I have NAT setup (eth0 = inside, eth1 = outside) > but need to get port forwarding going. What is the best way? Well it depends on what you are trying to forward But to turn on forward in general use this; /bin/echo 1 >/proc/sys/net/ipv4/ip_forward -- Regards Robert Smile... it increases your face value! _______________________________________________ CentOS mailing list CentOS at centos.org http://lists.centos.org/mailman/listinfo/centos