[CentOS] NAT from eth0:0 port 80 to lo port 8080?

Sun May 13 22:24:22 UTC 2007
Les Mikesell <lesmikesell at gmail.com>

Jeff Potter wrote:
> 
>> Why do you want to redirect the HTTP traffic to the same box?
> 
> So that jboss can be installed under a "vanilla" user account without 
> needing any superuser privileges, and so that the box doesn't have to be 
> configured in any way other than the iptables rule. Running on localhost 
> (or some 10.x.x.x IP) further removes any chance of direct port 8080 
> access (by some other admin accidently messing up a firewall rule).


I do it like this where $IP is the interface used by a load balancer 
front end:

/sbin/iptables -t nat -A PREROUTING -d $IP -p tcp --dport 80 -j REDIRECT 
--to-ports 8080
/sbin/iptables -t nat -A OUTPUT -d $IP -p tcp --dport 80 -j REDIRECT 
--to-ports 8080

In my case I do want it to answer directly on port 8080 on the interface 
too because I have a monitoring program that hits a test page there.  In 
retrospect it probably wasn't even worth limiting the original 
destination interface because these boxes have several and a setup 
script has to be run on each new box to figure out the $IP in the 
command - and it wouldn't have hurt to redirect them all.

-- 
   Les Mikesell
    lesmikesell at gmail.com