[CentOS] raid

Wed May 30 05:20:12 UTC 2007
CentOS List <centoslist at gmail.com>

> ----- Original Message ----- 
> ----- "CentOS List" <centoslist at gmail.com> escreveu:
> > >> > Set up md0 (Raid1) (sda,sdb)
> > >> > Set up md1 (Raid1) (sdc,sdd)
> > >> >
> > >> > Set up md2 (Raid0) (md0,md1)
> > >>
> > >> ok. That sounds easy.. I tried to do md0. It ask for me a mount
> > >> point.
> > >> What should I mount it on?
> > >
> > > The only thing you mount at the end of the day is md2
> > >
> > > Are you trying to set this up in the installer or somewhere else?
> >
> > Yes. During the installing of CentOS 5. I had specified hda and hba
> > as raid and when i wanted to create md0, it want me to supply a mount
> > point.
> > So i am stuck there.
> 
>   As far as I know, the CentOS installer didn't allow a RAID 1+0
> during install! But, I think you can setup this using RAID1 + LVM :
>    - Setup md0 (Raid1) (sda,sdb)
>    - Setup md1 (Raid1) (sdc,sdd)
>    - Setup LVM (md0+md1)
> 
> But i am stuck during the setup of md0 as it requires me to specified
> a mount point. 

> Well, select the partition type as LVM not ext2/3 and it will not ask 
>for a mount point :)

So where do i mount /boot / and swap?