> -----Original Message----- > From: centos-bounces at centos.org > [mailto:centos-bounces at centos.org] On Behalf Of Ruslan Sivak > Sent: Monday, May 07, 2007 12:53 PM > To: CentOS mailing list > Subject: [CentOS] Anaconda doesn't support raid10 > > So after troubleshooting this for about a week, I was finally able to > create a raid 10 device by installing the system, copying the > md modules > onto a floppy, and loading the raid10 module during the install. > > Now the problem is that I can't get it to show up in anaconda. It > detects the other arrays (raid0 and raid1) fine, but the raid10 array > won't show up. Looking through the logs (Alt-F3), I see the > following > warning: > > WARNING: raid level RAID10 not supported, skipping md10. > > I'm starting to hate the installer more and more. Why won't > it let me > install on this device, even though it's working perfectly from the > shell? Why am I the only one having this problem? Is nobody > out there > using md based raid10? Most people install the OS on a 2 disk raid1, then create a separate raid10 for data storage. Anaconda was never designed to create RAID5/RAID10 during install. -Ross ______________________________________________________________________ This e-mail, and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail, you are hereby notified that any dissemination, distribution or copying of this e-mail, and any attachments thereto, is strictly prohibited. If you have received this e-mail in error, please immediately notify the sender and permanently delete the original and any copy or printout thereof.