CentOS List wrote: >> ----- Original Message ----- ----- "CentOS List" >> <centoslist at gmail.com> escreveu: >> > >> > Set up md0 (Raid1) (sda,sdb) >> > >> > Set up md1 (Raid1) (sdc,sdd) >> > >> > >> > >> > Set up md2 (Raid0) (md0,md1) >> > >> >> > >> ok. That sounds easy.. I tried to do md0. It ask for me a mount >> > >> point. >> > >> What should I mount it on? >> > > >> > > The only thing you mount at the end of the day is md2 >> > > >> > > Are you trying to set this up in the installer or somewhere else? >> > >> > Yes. During the installing of CentOS 5. I had specified hda and hba >> > as raid and when i wanted to create md0, it want me to supply a mount >> > point. >> > So i am stuck there. >> >> As far as I know, the CentOS installer didn't allow a RAID 1+0 >> during install! But, I think you can setup this using RAID1 + LVM : >> - Setup md0 (Raid1) (sda,sdb) >> - Setup md1 (Raid1) (sdc,sdd) >> - Setup LVM (md0+md1) >> >> But i am stuck during the setup of md0 as it requires me to specified >> a mount point. > >> Well, select the partition type as LVM not ext2/3 and it will not ask >> for a mount point :) > > So where do i mount /boot / and swap? You can put / and swap on the LVM. /boot needs to be separate.