Kai Schaetzl wrote: > > I'm testing doing kickstart installations on Xen VMs. This is > the first time I'm trying out kickstart at all, so I rather think I'm > doing something wrong in the kickstart configuration than it is > a Xen issue. > > I use a modified kickstart file from an earlier manual installation > with a very basic filesystem setup. It fails with > "SystemError: vgcreate failed for VolGroup00". The Xen VM file is > allowed to grow up to 2GB. The kickstart commands for partioning are: > > clearpart --all --initlabel --drives=xvda > part /boot --fstype ext3 --size=100 --ondisk=xvda > part pv.2 --size=0 --grow --ondisk=xvda > volgroup VolGroup00 pv.2 --pesize=32768 pv.2 ^^^^^^^ Everything looks OK except you list the PV twice here, maybe that's the problem? Just remove the first pv.2 and see if that does it. > logvol / --fstype ext3 --name=LogVol00 --vgname=VolGroup00 > --size=1024 --grow > logvol swap --fstype swap --name=LogVol01 --vgname=VolGroup00 > --size=416 --grow --maxsize=832 > > This is taken exactly from the "template" kickstart file, I just > added the --initlabel after reading the kickstart tips on the wiki. > I read the kickstart part of the RH Installation and Deployment Guide, > but it didn't help in this respect. Apparently --pesize=32768 is a > maximum for volgroup extent sizes and is harmless. > > When I change to creating a partition for / it works just fine. > > Can someone help? Here is the typical desktop kickstart partitioning I use: clearpart --linux --initlabel --drives=sda part /boot --fstype ext3 --size=100 --ondisk=sda --asprimary part pv.0 --size=0 --grow --ondisk=sda volgroup CentOS --pesize=32768 pv.0 logvol / --fstype ext3 --name=root --vgname=CentOS --size=4096 --grow logvol swap --fstype swap --name=swap --vgname=CentOS --size=1024 I typically switch to a swap file after install because it's easier to customize, and with today's kernels and file systems it has been shown that performance is equivalent between swap files and swap partitions. Too bad kickstart doesn't have a option to create a swap file... -Ross ______________________________________________________________________ This e-mail, and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail, you are hereby notified that any dissemination, distribution or copying of this e-mail, and any attachments thereto, is strictly prohibited. If you have received this e-mail in error, please immediately notify the sender and permanently delete the original and any copy or printout thereof.