Peter Kjellstrom wrote: > On Monday 15 October 2007, Dan Carl wrote: > ... > >> But with errors >> In dmesg have this: >> sda: Mode Sense: bf 00 00 08 >> SCSI device sda: drive cache: write back >> sda: unknown partition table >> sd 0:0:0:0: Attached scsi disk sda >> > > Those are not errors. But it doesn't seem to have a partition table (see > below) > > >> I have no experience with the Smart Array Controller, just what I read the >> past couple of days. >> Here's how it was mounted on the HP server >> /dev/cciss/c0d1 /stor02 ext3 defaults 1 1 >> > > Ah, they put the ext3 directly on the device. Consistent with the above data. > > >> Is there a way I can get the data off the array with my Centos server? >> Any help/suggestions/tips would be greatly appreciated, I've hit a brick >> wall. >> > > Try "mount -oro /dev/sda /mnt/tmp" (or whatever) or just see if there's a > superblock there with "tune2fs -l /dev/sda". > he has a hardware raid set of drives originally from a HP/Compaq SmartArray controller, now connected to a simple non-raid scsi controller. sorry, thats not gonna play no way no how.