On Fri, Sep 07, 2007 at 03:32:55PM -0700, mark pryor wrote: > > > Chuck Campbell <campbell at accelinc.com> wrote: I have a new machine I'm trying to install Centos 5.0 on and I'm not getting > very far. > > Chuck, > > I'm suprised that the raid array wasn't named as > /dev/mapper/isw_xxxyyyxxx raid arrays are real hw raid on the 3ware card, and show up as very large disks. I was trying to install to a single drive (non raid) in the earlier messages. > > to be named as /dev/sdc suggests that anaconda didn't use dmraid. > To be sure that the installer missed using dmraid, you could do a quick knoppix (4.0+) live session and try to mount and read the fakeraid array named above. There are no fake raid arrays, just the hw raid arrays and the two individual disks, which show up as sda and sdb (very large 2Tb disks) and sdc, sdd which are the two single disks. > > If you don't find the isw_ device, then you will have to redo the install, adding the dmraid kernel parameter along with "dd text dmraid". The install never runs, it just hangs as I described, so I have nothing on any of the disks... > As far as the blank screen, while in the knoppix session try to see if your xorg.conf is missing a modeline. If missing, add a modeline suitable for your monitor. Not a blank screen, a screen full of hash with an X cursor which changes to the arrow, but I cvan't see anything in the the hashed up screen. I'll look for the xorg.conf details in knoppix, but how do I use those to do a centos graphical install? -chuck -- ACCEL Services, Inc.| Specialists in Gravity, Magnetics | (713)993-0671 ph. | and Integrated Interpretation | (713)993-0608 fax 633 1/2 W. 21st St.| Since 1992 | (713)306-5794 cell Houston, TX, 77008 | Chuck Campbell | campbell at accelinc.com | President & Senior Geoscientist | "Integration means more than having all the maps at the same scale!"