Siva GNU/Linux wrote: > Hi > I am using CentOS 5 64bit, i can install successfully on the below > hardware. while booting i can see the Pointer and use Mouse. But While > i get a Login screen I couldn't see the pointer, after login also i > can't. when i press CTRL button, it shows where the pointer is.. What > should i do to enable and work with Mouse. > > AMD Athlon 64 X2 3800+ > ASUS Nvidia Geforce Chipset board > 1GB DDR 2 > 80 GB SATA > 17" TFT > Logitech Optical Mouse > > > -- > cheers, > SivaPrakash.SK > +91-98840-57147. > ------------------------------------------------------------------------ > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > Hi Siva, I have been battling with the same problem for a few weeks now. From everything I can find it appears that the graphics controller on these motherboards (mine has the C15G nVidia chipset and the controller is recognised as a GEForce 6100). I followed Jim Perrin's instructions and downloaded and installed the nVidia driver from RPMForge and still have the same problem. My next step is to try to find a PCI or PCI express graphics card that is supported by Linux so that I can start using this server. The subject of the thread in which my problems were discussed is: "nVdia C15G chipset and GeForce 6100 on board graphix controller" Sorry that I cannot give you more positive feedback but hope that this helps in some way. ChrisG