On Fri, Apr 11, 2008, Milton Calnek wrote: >findfs comes to mind. > >other than that... >fdisk -l | grep That's fine -- once the system has been installed, but I'm looking for a general way when attempting kickstart installs on new hardware that may find devices in different places. >Bill Campbell wrote: >>Is there an easy way to specify the proper device location for >>the kickstart configuration file if it is on a USB flash or USB >>floppy drive? Depending on the hard disk configuration they >>might by /dev/sda, /dev/sdb, etc. >> >>On SuSE'autoyast instalattions, the system searches all available >>devices for an ``info'' configuration file. Does CentOS 5.x do >>something similar to find a ``ks.cfg'' file? >> >>Bill > >-- >Milton Calnek BSc, A/Slt(Ret.) >milton at calnek.com >306-717-8737 > > >-- >This message has been scanned for viruses and >dangerous content by MailScanner, and is >believed to be clean. > >_______________________________________________ >CentOS mailing list >CentOS at centos.org >http://lists.centos.org/mailman/listinfo/centos > -- Bill -- INTERNET: bill at celestial.com Bill Campbell; Celestial Software LLC URL: http://www.celestial.com/ PO Box 820; 6641 E. Mercer Way Voice: (206) 236-1676 Mercer Island, WA 98040-0820 Fax: (206) 232-9186 When a place gets crowded enough to require ID's, social collapse is not far away. It is time to go elsewhere. The best thing about space travel is that it made it possible to go elsewhere. -- Robert Heinlein