Timothy Selivanow wrote: > On Fri, 2008-04-11 at 15:14 -0400, John wrote: > > On Fri, 2008-04-11 at 14:08 -0500, Les Mikesell wrote: > > > Timothy Selivanow wrote: > > > > On Fri, 2008-04-11 at 14:26 -0400, John wrote: > > > >> If I paid a couple grand for a core switch i'd be calling Cisco! > > > >> > > > > > > > > They're not core switches, they're just the catalyst 2900XL which is a > > > > small 24 port switch. We've got stacks of these sitting unused, so I > > > > doubt they're too expensive/valuable. > > > > > > > > > > They were expensive once. Now they are end-of-life'd and you can't get > > > a support contract or a new IOS for them. > > > > > > > Yea there 8years old and do not support todays technology. All the way > > back to IOS 8.. > > It's running IOS 12.0(5)WC16, but running that command in enable didn't > work (also tried it in config). Thanks for all of your suggestions and > help. It's still pretty frustrating though... sw1-ven-nyc(config-if)#switch trunk encap ? dot1q Interface uses only 802.1q trunking encapsulation when trunking isl Interface uses only ISL trunking encapsulation when trunking It supports dot1q, you need to setup a port group for the 2 interfaces though and then configure trunking on that port group. -Ross ______________________________________________________________________ This e-mail, and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail, you are hereby notified that any dissemination, distribution or copying of this e-mail, and any attachments thereto, is strictly prohibited. If you have received this e-mail in error, please immediately notify the sender and permanently delete the original and any copy or printout thereof.