Toby Bluhm wrote: > Mufit Eribol wrote: >> >> I have a LV on RAID mounted as /mnt/raid. Then /mnt/raid/var is >> symlinked to /var. > > I was afraid you were going to say that. > > > Go back to single user mode. > > mkdir /new_var > cd /mnt/raid/var > tar cf - . | ( cd /new_var ; tar xvf - ) > > Make sure both dirs look the same. > > Change the link to /new_var. Or remove the old link & mv /new_var /var. > > reboot. Toby, Thank you for this nice tip. It worked perfectly. The server is back in the game again. Just for my learning experience, I would appreciate if you clarify one point though. Why are you afraid when you hear /mnt/raid/var symlinked to /var? Is something wrong with it? Here is my fstab: /dev/md2 / ext3 defaults 1 1 <--- md2 Software RAID1 /dev/md1 /boot ext3 defaults 1 2 <--- md0 Software RAID1 /dev/md0 /tmp ext3 defaults 1 2 <--- md1 Software RAID1 tmpfs /dev/shm tmpfs defaults 0 0 devpts /dev/pts devpts gid=5,mode=620 0 0 sysfs /sys sysfs defaults 0 0 proc /proc proc defaults 0 0 LABEL=SWAP-sda3 swap swap defaults,pri=1 0 0 LABEL=SWAP-sdb3 swap swap defaults,pri=1 0 0 /dev/raid_vg0/raid_lv0 /mnt/raid ext3 defaults 0 0 <--- Hardware RAID10 Before, home and var were under /mnt/raid directory and symlinked to /home and /var. Now, both directories were copied to / (md2 software RAID1) as new_home and new_var and /home and /var symlinks are now pointing to these new directories. /mnt/raid (hardware RAID10) which is the main storage of my server is not being used at the moment. I am planning to have 2 logical volumes (for home and var separately) instead of 1. Then, they will be mounted as separate partitions as /home and /var to /dev/raid_vg0/raid_lv0 and /dev/raid_vg0/raid_lv1, respectively. Is it a good approach? Please advise. Thank you again. Mufit