Akemi Yagi pisze: > On Sat, Aug 9, 2008 at 12:29 PM, Jancio Wodnik <jancio_wodnik at wp.pl> wrote: > >> Yahia Tachwali pisze: >> > > >>> to check for hdlc module but I could not find it... I guess I am missing >>> something to activate my new settings in the menuconfig. Is there a way to >>> verify that my new settings active!! Does any body know about the HDLC >>> modules loading in the 2.6.9. Please advise. And thank you all for your >>> help. >>> >> As i remember: hdlc is build not as module, it is core kernel module, not >> module to load by modprobe - so in menuconfig is [*] with hdlc not [M] as >> module. >> >> But maybe i'm wrong. >> > > Just to expand this a bit... > > Go to Device Drivers -> Networking support -> Wan interfaces -> Wan > interface support (y or n only). > > In the 'Wan interface support' menu, check 'Generic HDLC layer' (y, n, or M). > > Inside the 'Generic HDLC layer', there are a few support options (y or n) > > The above layout is for CentOS-5, but CentOS-5 is similar. Hope this helps, > > Akemi > you are right, only raw hdlc support and raw hdlc ethernet support are as [*]. My fault. Irek > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > > >