Thankyou again. I suppose I can take a look at smartd to get log files and have them forward to syslog-ng, unless smartd has an email feature :-) What does your smartd config look like for HP P400/800 controller? I would be curious to look at that. TIA On Sat, Aug 30, 2008 at 10:15 AM, Mogens Kjaer <mk at crc.dk> wrote: > Mag Gam wrote: >> >> Thankyou Anne. >> >> I just installed this and its seems to work. I am behind a RAID >> controller so hopefully anyone with cciss drivers can shed some light. >> I am able to see my logical devices but I have 6 drives per logical >> device. I would like to see all 12 drive status if possible. > > The RAID controller watches the SMART status of the drives for you. > > You should watch the status of the RAID controller. It should give > a warning if a drive is about to fail or has failed. > > I use array-info to get the status: > http://sourceforge.net/projects/array-info/ > > # /usr/local/bin/array-info -d /dev/cciss/c0d0 > Compaq Smart Array 5312 > Firmware revision : 2.58 > Rom revision : 2.58 > 1 logical drive configured. > > Logical drive 0 : > Fault tolerance : RAID 5 > Size : 957.10 GiB (2007181360 blocks of 512 bytes) > Status : Logical drive is ok > > Mogens > > -- > Mogens Kjaer, Carlsberg A/S, Computer Department > Gamle Carlsberg Vej 10, DK-2500 Valby, Denmark > Phone: +45 33 27 53 25, Fax: +45 33 27 47 08 > Email: mk at crc.dk Homepage: http://www.crc.dk > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >