I have this USB to CF device I tried to plug in today. Below is dmesg output when I plug it in. I was hoping it would look just like a USB thumbdrive. Is there something special I would have to do to be able to read the USB to CF device? Looks like its trying to make it /dev/sdd but I continue to get the errors at the end. Thank, jerry Dec 26 08:41:53 devgeisquad kernel: usb 1-4: new high speed USB device using ehci_hcd and address 83 Dec 26 08:41:53 devgeisquad kernel: usb 1-4: configuration #1 chosen from 1 choice Dec 26 08:41:53 devgeisquad kernel: scsi37 : SCSI emulation for USB Mass Storage devices Dec 26 08:41:58 devgeisquad kernel: scsi 37:0:0:0: Direct-Access Generic- Multi-Card 1.00 PQ: 0 ANSI: 0 CCS Dec 26 08:41:58 devgeisquad kernel: usb 1-4: USB disconnect, address 83 Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: [sdd] READ CAPACITY failed Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: [sdd] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK,SUGGEST_OK Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: [sdd] Sense not available. Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: [sdd] Write Protect is off Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: [sdd] Assuming drive cache: write through Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: [sdd] Attached SCSI removable disk Dec 26 08:41:58 devgeisquad kernel: sd 37:0:0:0: Attached scsi generic sg3 type 0 Dec 26 08:41:59 devgeisquad kernel: usb 1-4: new high speed USB device using ehci_hcd and address 84 Dec 26 08:42:14 devgeisquad kernel: usb 1-4: device descriptor read/64, error -110 Dec 26 08:42:29 devgeisquad kernel: usb 1-4: device descriptor read/64, error -110 Dec 26 08:42:29 devgeisquad kernel: usb 1-4: new high speed USB device using ehci_hcd and address 85 Dec 26 08:42:44 devgeisquad kernel: usb 1-4: device descriptor read/64, error -110