Jay Hilliard wrote: > In your pxelinux config file: > > add ksdevice=bootif > > also add "IPAPPEND 2" to the end of the file > > In your kickstart file, don't specify a device: > "network --bootproto dhcp" > > -Jay > > Karl R. Balsmeier wrote: >> yeah, it can be a bit daunting at first, but the below info is >> right. also consider down the road if you are using PXE/DHCP that >> there can be conflicts, so PXE to eth0, kickstart to eth1, that sort >> of thing. >> -krb >> >> nate wrote: >>> Keith Christian wrote: >>> >>> >>>> PXE begins the install with DHCP, so Kickstart should already know >>>> which of >>>> eth0, eth1, etc. to use. >>>> >>> >>> add ksdevice=eth0 to your kernel parameters, or eth1 if you want >>> to use eth1. This works for me anyways. >>> >>> nate --device= Used to select a specific Ethernet device for installation. Note that using --device= will not be effective unless the kickstart file is a local file (such as ks=floppy), since the installation program will configure the network to find the kickstart file. For example: network --bootproto=dhcp --device=eth0 Extracted from one of the pages I sent earlier. -Ross-