Nicolas Thierry-Mieg wrote: > > > Robert Moskowitz wrote: >>> That covers speed, but doesn't say anything about the duplex >>> setting. You should see this mentioned near the Ethernet driver load >>> lines in dmesg, too. >> >> Do you see anything in the lines I pasted above? Those are the only >> ones from dmesg. > > try: > ethtool eth0 thanks: ethtool eth1 Settings for eth1: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 32 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: d Current message level: 0x00000007 (7) Link detected: yes