Dunc wrote: > Johnny Hughes wrote: >> >> If there is something in the conf file that needs to change (that >> worked in 5.1 and does not in 5.2) let us know and we can add it to >> the release notes and/or wiki. >> > It was in the listening section as follows: > > # A space separated list of IP or host addresses where to listen in for > # connections. "*" listens in all IPv4 interfaces. "[::]" listens in all > IPv6 > # interfaces, but may also listen in all IPv4 interfaces depending on the > # operating system. Use "*, [::]" for listening both IPv4 and IPv6. > # > # If you want to specify ports for each service, you will need to configure > # these settings inside the protocol imap/pop3 { ... } section, so you can > # specify different ports for IMAP/POP3. For example: > # protocol imap { > # listen = *:10143 > # ssl_listen = *:10943 > # .. > # } > # protocol pop3 { > # listen = *:10100 > # .. > # } > listen = "*" > #listen = [::] > > The listen bit defaults to [::]. I had to change it to "*" as above > otherwise I couldn't connect to it. (connection refused) > > As it says above, [::] only listens on IPv4 'depending on the operating > system'. So something has changed from 5.1 to 5.2 which means that is no > longer the case. > > thanks > > Dunc That's strange Dunc. The new config file was written to /etc/dovecot/conf.rpmnew (as expected) for me, so your modified original doesn't get overwritten. I can see no difference between the 5.1 and 5.2 config files wrt the 'listen' directive. Mine was, and still is, set to the default [::] and still works fine. Further, I have IPv6 disabled on the server. I have tested on both i386 and x86_64 platforms and each are working fine both with and without ssl/tls. Did you restart the dovecot service after it was updated? (I'm not sure if yum update does this automatically or not when updating a daemon service that is running). Regards, Ned