Anything special needed to boot from a SAN in CentOS 5.1 x86-64 ? We have a new system running a QLA2342 FC HBA connected to a SAN, have a volume exported to it and would like to boot from it. We PXEboot kickstart and that works, the installer sees the disk, installs to it, and reboots. When GRUB tries to load all it prints is "GRUB" and sits there. When we try the Xen edition of CentOS 5.1, when GRUB tries to load the screen goes black and the system reboots. When we try VMWare ESX 3.5.0 it works perfectly, so the BIOS configurations and the SAN config is good, something specific with CentOS 5.1. I see in the release notes that SAN boot is supported, but doesn't give any special instructions. Anyone else booting CentOS directly from a FC SAN ? Any special considerations needed for multipathing and stuff when booting ? thanks nate