Hello all, I have an annoying networking issue. The value of arp_filter is getting changed. /proc/sys/net/ipv4/conf/eth0/arp_filter 1 I specifically set it to 0 via /sbin/ifup-local. The hosts in question are setup to test some network gear, and they all have 1 "management" interface and 1 or more through put interface. Any ideas on how to keep this value from changing? -- Milton Calnek BSc, A/Slt(Ret.) milton at calnek.com 306-717-8737 -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.