[CentOS] Gigabit Lan doesn't work

Rilawich Ango maillisting at gmail.com
Mon Nov 17 03:07:55 UTC 2008


Actually, I have 2 LAN cards.  eth0 is working as it is 10/100.  There
is a build-in gigalan which doesn't work.  I have to remove the 10/100
and make build-in lan works.

[root at localhost ~]# ethtool eth0
Settings for eth0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 32
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: d
        Current message level: 0x00000007 (7)
        Link detected: yes
[root at localhost ~]# ethtool eth1
Settings for eth1:
Cannot get device settings: No such device
Cannot get wake-on-lan settings: No such device
Cannot get message level: No such device
Cannot get link status: No such device
No data available


On Mon, Nov 17, 2008 at 10:54 AM, Barry Brimer <lists at brimer.org> wrote:
>>  I have installed Centos completely.  However, the LAN  doesn't work.
>> Below is the message after I issue.  How can I make it work?
>>
>> 00:19.0 Ethernet controller: Intel Corporation 82567V-2 Gigabit
>> Network Connection
>
> What does "ethtool eth0" tell you?
> _______________________________________________
> CentOS mailing list
> CentOS at centos.org
> http://lists.centos.org/mailman/listinfo/centos
>



More information about the CentOS mailing list