On Tue, Sep 2, 2008 at 8:44 PM, Richard Karhuse <rkarhuse at gmail.com> wrote: > > > On 9/2/08, Paolo Supino <paolo.supino at gmail.com> wrote: >> >> >> : >> >> Hi Joseph >> >> After sending the last reply I fixed the kickstart config files and >> added --boot=yes to the network statement of eth0, but going through the >> consoles of each of the systems to see if the installation completed >> successfully I found a few that got stuck on the network interface >> configuration screen (where it asks for IPv4 and IPv6 static/dynamic >> configuration information: "Configure TCP/IP"). >> > > I've only been half reading this thread, so feel free to ignore this > "interruption" ... > > Just plug one and only one NIC into the switch > Add "ksdevice=link" to your boot-up line (e.g. syslinux.cfg??). > > Configure network (if you must) or just let DHCP take over. > > Kickstart away .... > (works for me on boxes where during anaconda installation the NICs are > labeled one way, > but CentOS running system does another). > > Just a thought ... > > -rak- > > > > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > Hi Rak I don't ignore anyone :-) To be on topic: the kernel does receive the parameter ksdevice=bootif from the PXE bootloader. I tried to put eth0 instead of bootif, but it never worked (might be because of other configuration directives). I've pasted the configuration a couple of times in this thread so if you look back at one of the messages you will find the configurations I'm using ... -- TIA Paolo -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20080903/47165c34/attachment-0005.html>