Per Qvindesland wrote: > Have you tried this: > http://www.electrictoolbox.com/seg-fault-or-similar-nasty-error/ > > Per Yes, I have tried it, but that's a workaround, not a real solution. Glenn > > --- Original message follows --- > > *Subject: *Re: [CentOS] httpd crashes after signal HUP > *From: *"RedShift" <redshift at pandora.be> > *To: *"CentOS mailing list" <centos at centos.org> > *Date: *19-04-2009 9:49 > > > >----- Oorspronkelijk bericht ----- > >Van > : RedShift [mailto:redshift at pandora.be] > >Verzonden > : zondag > , april > 19, 2009 09:42 AM > >Aan > : centos at centos.org > >Onderwerp > : [CentOS] httpd crashes after signal HUP > > > >Hello > > > > > >I'm running CentOS 5.3 with httpd-2.2.3-22.el5.centos.x86_64 and > php-5.1.6-23.2.el5_3.x86_64. When the logrotate scripts run and send > the HUP signal to httpd, the httpd process quits instead of > reloading. The only thing I can find in the logs is this: > > > >[Sun Apr 19 04:02:04 2009] [notice] seg fault or similar nasty > error detected in the parent process > > > >There wasn't any segfault reported in dmesg and I couldn't find > anything else in the other logs (messages, etc...) > > > >It's reproducable every time, when I send the HUP signal to the > master httpd process the same thing happens. > > > >My configuration is nothing special, just the stock one, with a > few unnecesary modules commented out and one virtual host. > > > > A follow-up, I cannot seem to reproduce this on my laptop (using > i386 instead of x86_64) with the same configuration. > > > Glenn > >