Peter Peltonen wrote: > I have a fresh installed CentOS 5.3 server which should route traffic > between two networks like this: > > network A (Internet) -- eth0 (default gw) : server : eth1 -- network B (LAN) > > I have set in sysctl.conf > > net.ipv4.ip_forward = 1 > > and routing works fine like this. But when I switch on the iptables > service (with default setup, configured when installing the server), > routing stops working (or at least I cannot ping a server in network A > from network B). I guess the firewall is stopping it, so I read > > http://www.centos.org/docs/5/html/5.2/Deployment_Guide/s1-firewall-ipt-fwd.html > > and issued the commands > > # iptables -A FORWARD -i eth1 -j ACCEPT > # iptables -A FORWARD -o eth1 -j ACCEPT > > but that did not help. > > So I am asking: what is the correct iptables command to make forwarding work? > > Regards, > Peter > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > > my iptables like that: * iptables --table nat --append POSTROUTING --out-interface eth0 -j MASQUERADE * iptables --append FORWARD --in-interface eth1 -j ACCEPT Regards Firdaus i'm come from indonesia. :) -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20090831/6fab9a48/attachment-0005.html>