On Fri, Feb 20, 2009 at 3:58 PM, John Doe <jdmls at yahoo.com> wrote: > > I've been trying to setup keepalive (vrrp) with LVS in direct routing on Centos 5 and I am stuck... > Installed ipvsadm from the repo (had to touch /etc/sysconfig/ipvsadm because it complained it was missing) > Compiled keepalived-1.1.16.tar.gz > ...snip... Install keepalived from rpmforge instead of compiling your own. Because mostlikely your build of keepalived is without LVS support. (Check the output of the ./configure command to verify). I've always used the rpmforge package and it works for me. Regards, Tim P.S. : Dag, your keepalived package is a bit outdated. Could you update it ? -- Tim Verhoeven - tim.verhoeven.be at gmail.com - 0479 / 88 11 83 Hoping the problem magically goes away by ignoring it is the "microsoft approach to programming" and should never be allowed. (Linus Torvalds)