[CentOS] Centos 5.3, no AHCI on HP DL320 G5p?

Mon Jul 27 10:01:48 UTC 2009
chandlercody at gmail.com <chandlercody at gmail.com>

I had to disable it with ahci=no at boot time, have you tried ahci=yes at boot time of kernel?
------Original Message------
From: Ned Slider
Sender: centos-bounces at centos.org
To: CentOS mailing list
ReplyTo: CentOS mailing list
Subject: Re: [CentOS] Centos 5.3, no AHCI on HP DL320 G5p?
Sent: Jul 27, 2009 5:23 AM

Veiko Kukk wrote:
> I have one HP Proliant DL320 G5p, where for some reason, the AHCI mode 
> is not enabled. According to server specs, it should have AHCI/NCQ 
> capability, but ata_piix module gets loaded during bootup, not ahci module.
> Any ideas how to enable AHCI mode?
> 

I'm not sure for this particular model server, but normally this is a 
*BIOS* setting for the SATA controller.

_______________________________________________
CentOS mailing list
CentOS at centos.org
http://lists.centos.org/mailman/listinfo/centos


Sent on the Now Network™ from my Sprint® BlackBerry