I am convinced that my iproute2 tables are all messed up....In fact I found some errors in my initial post. # ip rule list 0: from all lookup 255 32766: from all lookup main 32767: from all lookup default /etc/iproute2/rt_tables # # reserved values # 255 local 254 main 253 default 0 unspec # # local # #1 inr.ruhep 200 Cable 201 T1 So Cable and T1 are not even showing up in the list. When I run my ip commands from the command line I get the following results for each line. # ip route add 173.11.51.44/30 dev eth2 src 173.11.51.45 table Cable # ip route add default via 173.11.51.45 table Cable # ip route add 173.11.51.44/30 dev eth2 src 173.11.51.45 RTNETLINK answers: File exists # ip route add default via 173.11.51.46 RTNETLINK answers: File Exists # ip rule add from 173.11.51.45 to default lookup Cable RTNETLINK answers: Numerical result out of range # ip route add 67.152.166.0/27 dev eth3 src 67.152.166.2 table T1 # ip route add default via 67.152.166.2 table T1 # ip route add 67.152.166.0/27 dev eth3 src 67.152.166.2 RTNETLINK answers: File Exists # ip rule add from 67.152.166.2 to default lookup T1 RTNETLINK answers: Numerical result out of range So the first few lines run fine for each table and then I start getting errors. Are these all the commands that I need to use to set this up? I know that when I first entered them by hand the T1 and Cable showed up in the tables list. Am I going crazy? -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20090701/2d1e3b9a/attachment-0005.html>