> -----Original Message----- > From: centos-bounces at centos.org > [mailto:centos-bounces at centos.org] On Behalf Of Thomas Dukes > Sent: Friday, July 03, 2009 5:55 PM > To: 'CentOS mailing list' > Subject: Re: [CentOS] ffmpeg and zoneminder install problems > > > > > -----Original Message----- > > From: centos-bounces at centos.org > > [mailto:centos-bounces at centos.org] On Behalf Of Gregory P. Ennis > > Sent: Friday, July 03, 2009 2:24 PM > > To: CentOS mailing list > > Subject: [CentOS] ffmpeg and zoneminder install problems > > > > CentOs zoneminder users, > > > > I have been trying to install zoneminder on Centos 5.3 > > (2.6.18-128.1.16.el5xen) and have hit a brick wall with > ffmpeg which > > zoneminder has as a dependancy. > > > > There were no rpm's in centos or rpmforge so I have followed the > > instructions on the zoneminder website for a CentOs install. > > > > I have posted a note on the zoneminder list, but have not > been able to > > get any takers to assist me. I am not a C programer so I > have a lack > > of understanding as to how to proceed. > > > > I have followed the steps outlined on zoneminder site as to how to > > install on Centos 5.3 > > > > http://www.zoneminder.com/wiki/index.php/CentOS > > > > The sequence step I have not been able to pass beyond with these > > instructions is the following : > > > > svn checkout -r 11879 svn://svn.mplayerhq.hu/ffmpeg/trunk > > ffmpeg cd ffmpeg/ ./configure make > > > > When I execute the make command I get the following that > results in an > > Error message. > > > > I noticed that some of you have been able to use zoneminder > on Centos > > 5.3, Can you help me get zoneminder installed. > > > > Thank you much, > > > > Greg Ennis > > P.S. here is the output of make > > > Sorry, > > I see you are following the guide. What version of > zoneminder are you trying to install? 1.23.3 will work with > ffmpeg 11879, but I had to use a more current version to get > 1.24.1 to complie. I'm using version 17697. > Its just what was available the day I re-installed 1.23.3 > after I have problems with 1.24.1. > > Do a search for my posts "tdukes" on the forum. I posted > some steps I used so I could go back to them if needed. > > Eddie > PS, I used the following configure parameters: --enable-shared --enable-swscale --enable-gpl --enable-pthreads