Hello, I just got back from a datacenter where I installed a new server running CentOS 5.3. I set up a software raid with md0 being /. (Only one mount, didn't split anything up.) I just discovered that instead of raid 1, it did raid 0... Not exactly what I wanted! Probably missed that little check when installing. So now, I need to change this. But since the whole OS is on this raided partition that I want to change, I'm a bit stuck. Is there a way to launch an installer while in the OS that I can re-install the whole thing over the internet, without having to physically go to the box? Speed of installation is not that much of an issue. It would obviously need to keep up some sort of shell with my current eth0 settings during the install. Thanks for any ideas! Bob