Sorry for mailing this to the wrong list. Rectified On Wed, 2009-06-17 at 14:21 +0200, Coert Waagmeester wrote: > Hello all, > > I have been running xen for a while now with two interfaces: > dummy0 for host only communication, and > eth0 for the outside network. > > my script looks like this: (/etc/xen/scripts/network-bridge-more) > ------------------------------------------------------------------ > #! /bin/sh > > dir=$(dirname "$0") > "$dir/network-bridge" "$@" vifnum=0 netdev=dummy0 bridge=xenbr0 > "$dir/network-bridge" "$@" vifnum=1 netdev=eth0 bridge=xenbr1 > ------------------------------------------------------------------ > > now i have a newer setup where eth0 and eth1 are bonded. > > If i change eth0 in the above script to bond0 it messes up the bond > completely and stops working. > > I have use /etc/xen/scripts/network-bridge-bonding, and that works, but > then I can only have one virtual network for my domU > > I have tried this: > ------------------------------------------------------------------ > #! /bin/sh > > dir=$(dirname "$0") > "$dir/network-bridge" "$@" vifnum=0 netdev=dummy0 bridge=xenbr0 > "$dir/network-bridge-bonding" "$@" vifnum=1 netdev=bond0 bridge=xenbr1 > ------------------------------------------------------------------ > > but that also does not work. > It also messes up my bond. > > Any tips would be greatly appreciated. > > Kind regards, > Coert > > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos