On Fri, 2009-11-27 at 22:10 -0500, Billy Huddleston wrote: > I just read the user manual on it.. It says the following... > > IT Mode (Initiator and Target Mode) > This is a Non-RAID mode. To use this mode, be sure to fl ash an IT > mode firmware to the EEPROM and to install an IT Mode driver to the > system OS. > > So, I'm confused, what point is a RAID controller that doesn't support > RAID ? > > Thanks, Billy Probably for compliance, might as well give it a try if you can... The Perc 4i/5i stuff that Steve was talking about is definitely supported as I have a server that uses this. They may be exposed and use different drivers than the straight LSI SAS 1068E. Steve: What module does your Dell Perc use? I don't have access to my server to check. -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 198 bytes Desc: This is a digitally signed message part URL: <http://lists.centos.org/pipermail/centos/attachments/20091127/4cc3dfec/attachment-0003.sig>