It's listed as a MegaRAID controller. I've tried the following drivers suggested by Supermicro with no success. megasr-13.10.0708.2009-1-rhel50-ga-all.img megasr-13.10.0708.2009-1-rhel50-u1-all.img megasr-13.10.0708.2009-1-rhel50-u2-all.img megasr-13.10.0708.2009-1-rhel50-u3-all.img From what I can tell from reading, it is a software RAID and putting it in IT mode makes it work as a JBOD. I'm not understanding how to do RAID 10 with it in IT mode. Thanks, Billy Larry Brigman wrote: > On Fri, Nov 27, 2009 at 2:35 PM, Billy Huddleston <billy at ivdc.com> wrote: > >> I'm trying to install CentOS 5.4 on a machine with a LSI SAS 1068E >> controller. I've googled all over the place and found a few different >> drivers for RHEL5 for it.. and tried a few of them.. Some will load, >> some complain that this isn't the correct version.. non of them work >> when it comes to showing Hard Drivers in the partition manager. The >> machine is a Supermicro SYS-6015V-M3 server. Any help would be appreciated. >> >> > > run lspci on the system from the rescue mode of the installer disk. > It will probably say something > like Megaraid. > > We have a newer motherbaord from Super Micro and we had the same problem. > The motherboard data info says LSI 1068E but depending on the jumper > setting of the board it could be > 1078E instead and that is not supported by Linux until a much later > kernel (2.6.32). > > Jumper for IT mode and get the IT firmware and things will work correctly. > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20091130/3ca371c1/attachment-0005.html>