On 1/5/2010 5:29 PM, Matt wrote: >>> I just installed CentOS 5.4 64 bit release on a 1.9ghz CPU with 8gB of >>> RAM. It has 2 Western Digital 1.5TB SATA2 drives in RAID1. >>> >>> [root at server ~]# df -h >>> Filesystem Size Used Avail Use% Mounted on >>> /dev/md2 1.4T 1.4G 1.3T 1% / >>> /dev/md0 99M 19M 76M 20% /boot >>> tmpfs 4.0G 0 4.0G 0% /dev/shm >>> [root at server ~]# >> >> Did you just create the RAIDs? It will something that size a few hours to >> complete the initial sync. Try 'cat /proc/mdstat' to see when the sync >> completes. Until then, expect to have head contention with anything else >> that might be trying to use the drives. > > Here is what I got there. Md1 is swap I beleive: > > [root at server ~]# uptime > 17:20:54 up 7 days, 3:26, 2 users, load average: 3.41, 2.93, 2.89 > [root at server ~]# > [root at server ~]# > [root at server ~]# cat /proc/mdstat > Personalities : [raid1] > md0 : active raid1 sdb1[1] sda1[0] > 104320 blocks [2/2] [UU] > > md1 : active raid1 sdb2[1] sda2[0] > 8385856 blocks [2/2] [UU] > > md2 : active raid1 sdb3[1] sda3[0] > 1456645568 blocks [2/2] [UU] That's working normally with the sync completed. Mirrors should run at close to the speed of a single drive. Maybe you are just expecting too much from SATA or you have something like an updatedb running. An 'hdparm -tT' against the partitions and md devices should give you an idea of what the drives can do. And top might show what's causing the load (but maybe not if it is mostly waiting on disk seeks). -- Les Mikesell lesmikesell at gmail.com