Georghy wrote: > Hi everyone, > I recently install VMware on a server using PAE kernel > > everything was great until I use vmware server > > everytime i'm connecting to the vmware server web interface > after few seconds, the client loose server connection (server shows a > loading page) > I can't access to my VM till I log on the server run /etc/init.d/vmware > restart > > I try to connect to the server again but connection still fails > > I try /etc/init.d/vmware stop > /etc/init.d/vmware start > > then it respond me : > > Starting VMware services: > Virtual machine monitor [FAIL] > Virtual machine communication interface [ OK ] > VM communication interface socket family: [FAIL] > Virtual ethernet [FAIL] > Bridged networking on /dev/vmnet0 [ OK ] > > I retry /etc/init.d/vmware start > > VMware Server is installed, but it has not been (correctly) configured > for the running kernel. To (re-)configure it, invoke the > following command: /usr/bin/vmware-config.pl. > > I try /usr/bin/vmware-config.pl but it doesn't work until I reboot > > I do reboot but connection fails again and I have to do the same thing > above. > > what should I do to make thing working. > > /All help greatly/ appreciated > Hi Georghy, I run VMware server 2 on PAE kernel. Are you running 2.0.2? I had the same problem as you when running < 2.0.2 2.0.2 has been fixed to work with CentOS 5.4 without that glibc trick on the CentOS bug tracker. I have so far not had any problems with my installation. Regards, Coert