Nothing in the dmesg except this: Broadcom NetXtreme II Gigabit Ethernet Driver bnx2 v2.0.2 (Aug 21, 2009) eth0: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit 133MHz found at mem e6000000, IRQ 16, node addr 0024e848f03d eth1: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit 133MHz found at mem e8000000, IRQ 17, node addr 0024e848f03f eth2: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit 133MHz found at mem ea000000, IRQ 19, node addr 0026b9662f43 eth3: Broadcom NetXtreme II BCM5708 1000Base-T (B2) PCI-X 64-bit 133MHz found at mem ec000000, IRQ 20, node addr 0026b9662f45 Paras. On Wed, Oct 13, 2010 at 5:47 PM, Les Mikesell <lesmikesell at gmail.com> wrote: > On 10/13/2010 5:26 PM, Paras pradhan wrote: >> Hi, >> >> I don't have ifcfg-eth1 in my /etc/sysconfig/network-scripts. But when >> I do ifconfig eth1 I can see output as below. If I do ifconfig eth12 , >> I don't see anything which i am assume is normal. >> >> >> eth1 Link encap:Ethernet HWaddr 00:24:E8:44:DB:CC >> BROADCAST MULTICAST MTU:1500 Metric:1 >> RX packets:0 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) >> Interrupt:17 Memory:e8000000-e8012800 >> >> >> Don't know why and how this is happening. > > The output of 'dmesg' should show some details about the device detected > as eth1. > > -- > Les Mikesell > lesmikesell at gmail.com > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >