On Sat, 2010-09-18 at 16:08 -0700, Raymond Jender wrote: > I am pulling my hair out here folks...... > > I am running CentOS 5.5 in command line only. Reason being I am > standing up an IDS system on it. > > I have installed the NX client/node and server pkgs. I have installed > the NX client for windows on a Vista box. When I attemtp to connect > from the Vista to CentOS, I get this: > > NX> 203 NXSSH running with pid: 22080 > NX> 285 Enabling check on switch command > NX> 285 Enabling skip of SSH config files > NX> 285 Setting the preferred NX options > NX> 200 Connected to address: 192.168.1.70 on port: 22 > NX> 202 Authenticating user: nx > NX> 208 Using auth method: publickey > NX> 204 Authentication failed. > > Now I have been googling and re-googling. Plenty of people have had > the same issue, but I have yet to find a solution that works for me. > Funny that most of the stuff I'm finding on google is 4-5 years old! > I'm sure I am probably missing something so simple I will puke! > > I think I read that someone did an install and it worked right out of > the box!! Incredible! > > I'd really like to see a CentOS - NX configuration guide but couldn't > find one. > > Can someone just tell me how this should be configured....what changes > do I need to > make and to what config files? > > ssh (putty and WinSCP) works just fine for me in case you need to > know. > > If you need any particular information, please let me know. > > Thanks. > > Ray > ---- usually when that happens, that means you didn't copy the client.id_dsa.key from /etc/nxserver to the client and set that key in the client setup. Craig -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.