[CentOS] HP Smart Array B110i SATA RAID Controller
Anton Turon
marcus at mrcs.skFri Dec 2 09:18:10 UTC 2011
- Previous message: [CentOS] JNLP app problems
- Next message: [CentOS] DHCP_HOSTNAME in ifcfg-eth0
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Richard, we have just installed a CentOS 5.5 on 320G6 with B110i controller. As you correctly said, the CentOs shows both devices while booting w/o dd. However, as we have found, contrary to what is said in release notes for the controller DD, you must not dd it, however, just unzip it and place the .dd file on your flash disk, preferrably formatted in plain FAT16(vfat). After that, boot up your CentOS install disk with 'linux dd' option. CentOs will accept the dd file from the flash disk w/o further complaints. Note though, that even though the CentOs will install over the RAID1+0 virtual volume, sda and sdb will still be shown in the device tree, although the B110i will correcly write to both devices. Anton
- Previous message: [CentOS] JNLP app problems
- Next message: [CentOS] DHCP_HOSTNAME in ifcfg-eth0
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list