Same Problem here, the harddrive (2.5" Samsung HM121HC) running with
Kernel 2.6.18-194.32.1.el5 (x86_64) produces errors on high load.
With one step back kernel the errors are gone. Im already changed the
harddrive with a new one, same errors on the newest kernel.
dmesg output:
hdc: status error: status=0x58 { DriveReady SeekComplete DataRequest }
ide: failed opcode was: unknown
hdc: drive not ready for command
attempt to access beyond end of device
hdc3: rw=0, want=25863980832, limit=225841770
attempt to access beyond end of device
hdc3: rw=0, want=7830939224, limit=225841770
attempt to access beyond end of device
hdc3: rw=0, want=31645262224, limit=225841770
attempt to access beyond end of device
hdc3: rw=0, want=25863980832, limit=225841770
attempt to access beyond end of device
hdc3: rw=0, want=25863980832, limit=225841770
hdc: status error: status=0x58 { DriveReady SeekComplete DataRequest }
ide: failed opcode was: unknown
hdc: drive not ready for command
There are no errors logged in smart, i already try'd with smartctl -t
long .... no errors. I also did a blocktest on this drive.
Next step is to change the cables, but i don't think this would be a
solution, i think it's a kernel IDE / DMA problem.
Wolfgang
Am 15.01.11 14:50, schrieb Ryan Wagoner:
> On Sat, Jan 15, 2011 at 7:57 AM, Keith Roberts <keith at karsites.net> wrote:
>> I hope to be be getting some custom made 80 wire UDMA IDE
>> cables sorted ASAP. That should squeeze extra speed from all
>> the drives on the machine.
> You shouldn't need custom cables. IDE 80 pin cables can be sourced all
> over the Internet for around $5 a cable. Prices have gone up since
> they are now not common. You might even post a wanted ad on craigslist
> and see if you can get a handful for a few bucks.
>
> Ryan
> _______________________________________________
> CentOS mailing list
> CentOS at centos.org
> http://lists.centos.org/mailman/listinfo/centos