On 7/8/11, John J. Boyer <john.boyer at abilitiessoft.com> wrote: > I've installed autoconf and automake from the CentOS repository. When I > get liblouisutdml from its repository and run the autogen.sh script and > then configure I get the error I explained in my previous message. You're assuming that everybody saw the message. I would like to help but a quick check of my mailing list inbox only shows you asking questions about hostname and changing swap memory size. > Autoconf is generating a bad configure script. I've had the same problem > on other CentOS installations, and nobody could figure out what it was. > The nearest I can come is that some development file is missing from > CentOS. This is not a problem for me to look at but for the CentOS > experts. I just want to get my project to build, as it did on rhel. If I > need to install something else from the CentOS repository, please tell > me what. Even if you want the experts to look at it, at the very least you have to investigate and narrow down the minimum steps necessary to replicate the problem. Usually this means providing the exact commands you are using so that they can try to replicate it simply by changing only the necessary parameters like path names. Nobody is going to waste time trying to figure out what you were trying to do, how you were going about it, in order to trigger the error. Otherwise, you may just get replies that "it works fine for me" and none the wiser what might had gone wrong. Last but not least, try to follow the rules in the place you're asking for help. Quote then reply, please do not top post, i.e. post your responses above everything else which confuses people who just started reading and therefore less likely to want to help.