[CentOS] how to enable Flow Control on CentOS?
R - elists
lists07 at abbacomm.netThu Jul 7 13:22:36 UTC 2011
- Previous message: [CentOS] how to enable Flow Control on CentOS?
- Next message: [CentOS] how to enable Flow Control on CentOS?
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
rudi when migrating some rackmount HP servers running Centos4 from hard coded 100 meg fdx to auto gigE that we had to 1) remove this from our ifcfg-ethX files ETHTOOL_OPTS="speed 100 duplex full autoneg off" 2) proper CAT6 wiring 3) plug into the copper gigE switchport 4) reboot using Cisco though... did not find a decent plug n play solution i.e., did not waste a lot of time looking for solutions other than the obvious cisco and centos config or network down and up interface commands - rh
- Previous message: [CentOS] how to enable Flow Control on CentOS?
- Next message: [CentOS] how to enable Flow Control on CentOS?
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list