Hi, On Wed, Mar 9, 2011 at 6:57 PM, Les Mikesell <lesmikesell at gmail.com> wrote: > Some controllers want to map arrays to volumes and present the volumes > to the OS instead of drives, so you have to go through the motions of > assigning the resources to volumes and initializing them even if you > only want one disk in the array or volume. I am pretty sure this was done already as that was what I had been told, and I remember seeing on the screen during the bootup messages about the drives being initialized and RAID5 working ok. But its been a while since I've been working with hardware issues so I will double check this tomorrow and show you the config. So is it so that the LSI 1068E Controller *should* be supported by megaraid_sas driver and the net install should use it without any driver disk needed? Regards, Peter