Hello, Thanks for your answer. Thing is, I will install plesk on this server and what i imagined was to make document root for vhosts to be on different drive. On one of servers, i made vhost.conf file and changed document root, and later had problems with cgi-bin folder etc. Thought like, since changing document root with plesk is kinda pain for my experience, what can i configure to have my websites, and later added domains run with no problem? Linux is installed on sda 120 gb ssd disk, raid one drive ready to be mounted at /dev/md0 3 tb free disk. Best regards 2011/11/21 Reindl Harald <h.reindl at thelounge.net>: > > > Am 21.11.2011 12:50, schrieb Adil BOYUN: >> Hello, >> >> I have fresh install CentOS 6 x64 running on my server. I have a raid >> 1 drive 3 tb ready to be mounted. I want to mount this as var folder, >> could achive this but after reboot, server didn't start, maybe i had >> problem with command cp -rf. >> >> Is this possible to do in a proper manner, with what commands? >> I used rsync and diff game me like 10+ output. > > well as long /var is containing "/var/lib" and "/var/cache" than more > applications / services are running more possible changes you will get > while the sync is running > > i would boot the machine with a live-cd and finalize these changes there > on the other hand i would NOT move the whole /var to an own partition > > normally "/var/cache" and "/var/log" two own partitions or if it is > a virtual machine in two different virtual disks should be enough > to prevent fill the root-fs and the different disks makes it much > easier resize/replace them if needed > > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos