On 10/08/12 03:33, Richard Reina wrote: > I have just installed 6.3 on a machine that was previously running > 5.8. Under 5.8 eth0 was eth0. Now with 6.3 /sbin/ifconfig gives me lo, > wlan0 and p4p1 (instead of eth0). I would like to make the ethernet a > static IP as I intend to for this to be machine used on my LAN only. > However, when I do /usr/sbin/setup -> Network Configuration the device > is not listed. Can anyone tell me why this is happening and how I can > fix it. Or if not how I can set a static and persistent IP address for > the ethernet? try editing /etc/udev/rules.d/70-persistent-net.rules change p4p1 to eth0 as the value for NAME reboot hope this helps K -- Kahlil (Kal) Hodgson GPG: C9A02289 Head of Technology (m) +61 (0) 4 2573 0382 DealMax Pty Ltd (w) +61 (0) 3 9008 5281 Suite 1415 401 Docklands Drive Docklands VIC 3008 Australia "All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer." -- IBM maintenance manual, 1925