I can't get IPv6 routing to configure correctly despite everything I've read saying it should This is my network config on a fully-updated CentOS 5.8 system: # cat /etc/sysconfig/network NETWORKING=yes NETWORKING_IPV6=yes HOSTNAME=my.hostname.com GATEWAY=aaa.bbb.ccc.ddd IPV6_DEFAULTGW=2a02:aaaa.bbbb::1 IPV6_DEFAULTDEV=eth0 # cat /etc/sysconfig/network-scripts/ifcfg-eth0 ONBOOT=yes DEVICE=eth0 BOOTPROTO=static HWADDR=52:54:00:68:42:1E IPADDR=000.111.222.333 NETMASK=255.255.255.128 IPV6INIT=yes IPV6ADDR=2a02:aaaa.bbbb:178:209:50:230:0/112 Attempts to use the IPv6 address fail. For example: # ping6 -c 2 2a00:1450:4016:800::1013 connect: Network is unreachable However it works if I manually enter these 2 lines: # route -A inet6 add ::/0 dev eth0 # ip -6 route add 2000::/3 via 2a02:aaaa.bbbb::1 metric 1 # ping6 -c 2 2a00:1450:4016:800::1013 PING 2a00:1450:4016:800::1013(2a00:1450:4016:800::1013) 56 data bytes 64 bytes from 2a00:1450:4016:800::1013: icmp_seq=0 ttl=57 time=91.2 ms 64 bytes from 2a00:1450:4016:800::1013: icmp_seq=1 ttl=57 time=95.3 ms These are the routing table entries added by my hand-added configuration: 2000::/3 via 2a02:418:6a04::1 dev eth0 metric 1 expires 21333054sec mtu 1500 advmss 1440 hoplimit 4294967295 default dev eth0 metric 1 expires 21333054sec mtu 1500 advmss 1440 hoplimit 4294967295 So... given the parameters set in my config files, why are the CentOS v5.8 initscripts not configuring my IPv6 routing correctly? One more thing. I get this output on network start up (prior to hand-configuration): Bringing up interface eth0: WARN : [ipv6_add_route] 'No route to host' adding route '::/0' via gateway '2a02:aaaa.bbbb::1' through device 'eth0' Thanks.