Am 12.05.2012 18:59, schrieb Gregory P. Ennis: > On 5/12/2012 11:39 AM, Gregory P. Ennis wrote: >> OK, I do have lspci on this system; I am going to it down and put the >> st1000spex back in the slot, and will send the lspci out put after I >> reboot. >> >> Greg > is the eth cable plugged in all the way? > _______________________________________________ > > Bob, > > At this point i would sure take the fix if that were the problem. I > have the lights active on the mother board nic and the nic on the > st1000spex. > > Here are the facts of the scenario that I have with the st1000spex > inserted in the pci-e slot : > > lspci : > 01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. > RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 03) > 02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. > RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 06) > > The first entry references the mother board nic and the second > references the st1000spex. Since both of these cards seem to have the > same chipset i would think this would be an easy thing to set up. > > ifconfig only displays eth0, and does not display eth1 > > > When I execute the command : > > service network restart > > eth0 is removed and restarted > > then I get : > > Bringing up interface eth1: Device eth1 does not seem to be present. > delaying initialization. Are both devices specified within /etc/udev/rules.d/70-persistent-net.rules? > I have NetworkManager turned to off > > I have /etc/sysconfig/networking/ > #PCI-E Slot #1 > #StarTech 10/100/1000 > #HWADDR=00:0A:CD:1E:4D:F6 > DEVICE=eth1 > NAME="Internal Facing Network eth1" > ONBOOT=yes > NM_CONTROLLED=no > TYPE=Ethernet > BOOTPROTO=none > IPV4_FAILURE_FATAL=yes > IPV6INIT=no > DEFROUTE=yes > IPADDR=10.0.0.134 > NETMASK=255.255.255.0 > DNS1=127.0.0.1 > DOMAIN="pomec.net" > UUID=4f637674-df3f-4fa8-a81a-8259563a1b1f > PREFIX=24 > USERCTL=no > > > I have /etc/sysconfig/network-scripts/icfg-eth1 > > set to : > > #PCI-E Slot #1 > #StarTech 10/100/1000 > #HWADDR=00:0A:CD:1E:4D:F6 > DEVICE=eth1 > NAME="Internal Facing Network eth1" > ONBOOT=yes > NM_CONTROLLED=no > TYPE=Ethernet > BOOTPROTO=none > IPV4_FAILURE_FATAL=yes > IPV6INIT=no > DEFROUTE=yes > IPADDR=10.0.0.134 > NETMASK=255.255.255.0 > DNS1=127.0.0.1 > DOMAIN="pomec.net" > UUID=4f637674-df3f-4fa8-a81a-8259563a1b1f > PREFIX=24 > USERCTL=no Alexander