[CentOS] True bond howto for Centos 6

aurfalien aurfalien at gmail.com
Sun May 13 20:18:39 UTC 2012


On May 13, 2012, at 2:43 PM, Digimer wrote:

> On 05/13/2012 11:45 AM, aurfalien wrote:
>> Hi all,
>> 
>> Read many posts on the subject.
>> 
>> Using 802.3ad.
>> 
>> Few problems;
>> Cannot ping some hosts on the network, they are all up.
>> Cannot resolve via DNS which is one of the hosts that I cannot ping, internal nor external DNS hosts.
>> Unplugging the NICS and plugging them back in will then not allow pining if the default d=gateway.
>> 
>> When cold booting it somewhat works, some hosts are pingable while others are not.
>> 
>> When restarting the network service via /etc/init.d/network, nothing is pingable.
>> 
>> Here are my configs;
>> 
>> ifcfg-bond0
>> DEVICE=bond0
>> USERCTL=no
>> BOOTPROTO=none
>> ONBOOT=yes
>> IPADDR=10.0.0.10
>> NETMASK=255.255.0.0
>> NETWORK=10.0.0.0
>> TYPE=Unknown
>> IPV6INIT=no
>> 
>> ifcfg-eth0
>> DEVICE=eth0
>> BOOTPROTO=none
>> ONBOOT=yes
>> MASTER=bond0
>> SLAVE=yes
>> USERCTL=no
>> 
>> ifcfg-eth1
>> DEVICE=eth1
>> BOOTPROTO=none
>> ONBOOT=yes
>> MASTER=bond0
>> SLAVE=yes
>> USERCTL=no
>> 
>> /etc/modprob.d/bonding.conf
>> alias bond0 bonding
>> options bond0 mode=5 miimon=100
>> 
>> Bonding worked great in Centos 5.x, not so well for me in Centos 6.2.
>> 
>> My goal is to get this working under bridging for KVM, I can only imagine the nightmare seeing I can't get a simple bond to work!
>> 
>> Any guidance is golden.
>> 
>> - aurf
> 
> I run KVM VMs, built and managed using libvirt, through bonded
> interfaces all the time.
> 
> I don't have a specific tutorial for this, but I cover all the steps to
> build a mode=1 (Active/Passive) bond and then routing VMs through it as
> part of a larger tutorial.
> 
> Here are the specific sections I think will help you;
> 
> https://alteeve.com/w/2-Node_Red_Hat_KVM_Cluster_Tutorial#Network
> 
> This section covers building 3 bonds, which you only need one of. In the
> tutorial, you only need to care about the "IFN" bond and bridge (bond2 +
> vbr2).
> 
> https://alteeve.com/w/2-Node_Red_Hat_KVM_Cluster_Tutorial#Provisioning_vm0001-dev
> 
> This covers all the steps used in the 'virt-install' call to provision
> the VMs, which includes telling them to use the bridge.
> 
> Hope that helps.

WOW, thanks Digi!

Will def read it.

I've another server to test and roll out soon and want to revisit bond+bridge in Centos 6.

This one unfortunately needs to be prime time tomorrow and I don't have enough resources (ie; brain power) to try the bond endeavor.

- aurf


More information about the CentOS mailing list