Hello All,
I ended up answering my own question, but figured I'd share this and open
up for discussion.
It is possible to set a metric with 'route' or `ip route`.
What I'm wondering is if there's a Red Hat/CentOS way of assigning a metric
in the network-scripts?
Answer:
[0] (from 2008) works.
ex: METRIC=10
Deployment Guides: EL5 [1] and EL6 [2] do not mention metrics on the
previous interface configuration pages.
*** The output from `ifconfig` does NOT show the metric as I set it, but
the output from `route` does.
I suppose this is the intended behavior?
The default gateway route would have the metric and not the interface.
Notice "Metric: 1" and "UG 10" below.
>From my test box (EL6):
~]# ifconfig eth0 | grep ric; route -n | grep G
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Destination Gateway Genmask Flags Metric Ref Use
Iface
0.0.0.0 192.168.X.Y 0.0.0.0 UG 10 0 0 eth0
[0]
http://www.cyberciti.biz/faq/rhel-fedora-centos-setup-routing-metric-networkdevice/
[1]
https://access.redhat.com/knowledge/docs/en-US/Red_Hat_Enterprise_Linux/5/html/Deployment_Guide/s1-networkscripts-interfaces.html
[2]
https://access.redhat.com/knowledge/docs/en-US/Red_Hat_Enterprise_Linux/6/html/Deployment_Guide/s1-networkscripts-interfaces.html
Have a great day,
--
---~~.~~---
Mike
// SilverTip257 //