Chris,
I've used software raid quite a bit, and have developed a few rules of thumb, hope these help!
- Use one raid array, generally md0, for /boot, and one for LVM, md1. This allows the individual drives to be mounted and read on another server for recovery if you're using RAID1.
This is generally how the drives in a RAID1 array would look. This is from a CentOS 5 server, so /boot is only 100MB, on CentOS 6 it would be 500MB.
# fdisk -l /dev/sda
Disk /dev/sda: 250.0 GB, 250059350016 bytes
255 heads, 63 sectors/track, 30401 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 * 1 13 104391 fd Linux raid autodetect
/dev/sda2 14 30401 244091610 fd Linux raid autodetect
# cat /proc/mdstat
Personalities : [raid1]
md0 : active raid1 sdb1[1] sda1[0]
104320 blocks [2/2] [UU]
md1 : active raid1 sdb2[1] sda2[0]
244091520 blocks [2/2] [UU]
- Avoid software RAID5 or 6, only use it for RAID1 or 10. Software RAID5 performance can be abysmal, because of the parity calculations and the fact that each write to the array requires that all drives be read and written. Older hardware raid controllers can be pretty cheap on eBay, I'm using an old 3Ware on my home CentOS server. Avoid hostraid adapters, these are just software raid in the controller rather than the OS. Even with hardware raid performance won't be near as good as RAID10, I generally only use RAID5 or 6 for partitions that hold backups.
If you are using drives over 1TB, consider partitioning the drives into smaller chunks, say around 500MB, and creating multiple arrays. That way if you get a read error on one sector that causes one of the raid partitions to be marked as bad, only that partition needs to be rebuild rather than the whole drive.
Mark Snyder
Highland Solutions
200 South Michigan Ave., Suite 1000
Chicago, IL 60604
http://www.highlandsolutions.com
----- Original Message -----
From: "Chris Weisiger" <cweisiger at bellsouth.net>
To: centos at centos.org
Sent: Monday, March 4, 2013 9:53:48 PM
Subject: [CentOS] Software RAID complete drives or individual partitions
I have been reading about software raid. I configured my first software raid system about a month ago.
I have 4 500 Gig drives configured in RAID 5 configuration with a total of 1.5TB.
Currently I configured the complete individual drivers as software raid, then created a /dev/md0 with the drives
I then created a /file_storage partition on /dev/md0.
I created my /boot / and swap partitions on a non raid drive in my system.
Is the the proper way to configure software raid?
_______________________________________________
CentOS mailing list
CentOS at centos.org
http://lists.centos.org/mailman/listinfo/centos