On 03/11/2013 01:05 AM, Mihamina Rakotomandimby wrote: > Hi all > > I get a Cisco 1841 router, connecting the office through a CHAP PPPoE link: > [...] > interface Dialer1 > ip address negotiated > ip mtu 1492 > ip nat outside > ip virtual-reassembly > encapsulation ppp > ip tcp adjust-mss 1452 > dialer pool 1 > dialer-group 1 > no cdp enable > ppp authentication chap callin > ppp chap hostname username at isp > ppp chap password 0 s0meStr0ngP4sswd > [...] > > > As a fallback solution, I would like to setup a CentOS Dual NIC 1U unit. > I dont want to use NetworkManager, I'd rather use the bare interface > configuration tools. > I'm running CentOS 6.3 > > > I looked for the right way to configure the internface: > - http://goo.gl/UaNBe: officiel doc, found no indication. > - http://goo.gl/DQ5Gk: using rp-pppoe, is it the right way? > - http://goo.gl/PTaes: seem to be right, but which package is it from? I am sure someone has something more current, I think my old box was running C5.3 or even earlier. I saved the control files off it and my ifcfg-ppp0 was: USERCTL=no BOOTPROTO=dialup NAME=DSLppp0 DEVICE=ppp0 TYPE=xDSL ONBOOT=yes PIDFILE=/var/run/pppoe-adsl.pid FIREWALL=NONE PING=. PPPOE_TIMEOUT=80 LCP_FAILURE=3 LCP_INTERVAL=20 CLAMPMSS=1412 CONNECT_POLL=6 CONNECT_TIMEOUT=60 DEFROUTE=yes SYNCHRONOUS=no ETH=eth0 PROVIDER=DSLppp0 USER='me at isp.net' PEERDNS=no DEMAND=no PERSIST=no IPV6INIT=yes PPPD_EXTRA="ipv6 ," There was also a ppp directory that had files: options, pap-secrets, and chap-secrets But like I said, old box.